Surge Protection
KEN-SG/TC Series Surge Protector for Control Signal

Requirement class to VDE 0675:D
Requirement class to EN61643-11: Type 3
Requirement class to IEC61643-1: Class III

Application Range:

KEN-SG/TC series DIN rail surge protective devices for control signal are applied to the surge protection of control signal and twisted data pair, which can prevent various dialing equipment from permanent damage or transient interruption arising from inductive overvoltage, over current and other transient surge voltage caused by surge and industrial noise, etc.

Main Features:

1. Adopt 35mm standard DIN rail, convenient for installation and use.
2. Adopt multilayer protection technology, strong protection ability, high reliability.
3. Built-in 4mm² elevating terminal, strong wiring ability, more reliable grounding.
4. Small volume, exquisite, flexible and convenient combination, strong adaptability.

KEN-SG/TC-5

Surge ProtectorNominal operating voltage Un:5V
Max. continuous operating voltage Uc:8V
Voltage protection level Up (Line to line):<80V
Nominal discharge current In(8/20):5kA
Transmission rate Vs:2M

KEN-SG/TC-12

Surge ProtectorNominal operating voltage Un:12V
Max. continuous operating voltage Uc:18V
Voltage protection level Up (Line to line):<80V
Nominal discharge current In(8/20):5kA
Transmission rate Vs:2M

KEN-SG/TC-5

Surge ProtectorNominal operating voltage Un:24V
Max. continuous operating voltage Uc:36V
Voltage protection level Up (Line to line):<80V
Nominal discharge current In(8/20):5kA
Transmission rate Vs:2M